Home Index Site Map Up: Glassmaking Navigation
Up: Glassmaking

First: Gilbert · Glass Blowing · Cover Last: Gilbert · Glass Blowing · Page 62 Prev: Gilbert · Glass Blowing · Page 46 Next: Gilbert · Glass Blowing · Page 48 Navigation
Gilbert: 50 of 65
·Cover ·Page 20 ·Page 42
·Page i ·Page 21 ·Page 43
·Page ii ·Page 22 ·Page 44
·Page 1 ·Page 23 ·Page 45
·Page 2 ·Page 24 ·Page 46
·Page 3 ·Page 25 ·Page 47
·Page 4 ·Page 26 ·Page 48
·Page 5 ·Page 27 ·Page 49
·Page 6 ·Page 28 ·Page 50
·Page 7 ·Page 29 ·Page 51
·Page 8 ·Page 30 ·Page 52
·Page 9 ·Page 31 ·Page 53
·Page 10 ·Page 32 ·Page 54
·Page 11 ·Page 33 ·Page 55
·Page 12 ·Page 34 ·Page 56
·Page 13 ·Page 35 ·Page 57
·Page 14 ·Page 36 ·Page 58
·Page 15 ·Page 37 ·Page 59
·Page 16 ·Page 38 ·Page 60
·Page 17 ·Page 39 ·Page 61
·Page 18 ·Page 40 ·Page 62
·Page 19 ·Page 41

EXPERIMENTAL GLASS BLOWING

 
the book. Does the water run from both tumblers to the lower tumbler until the levels are again the same?
Experiment 58. To make a repeating air gun.
    Take a full length of No. 4 tubing, put a branch about 3 inches long at a point about 2 inches from one end;
Balancing Columns
FIG. 81
BALANCING COLUMNS
leave the end of the branch closed (Fig. 78). Now load the branch with shot or coarse dry sand, and your repeating air gun is ready for use.
    Tilt the branch slightly above the horizontal and blow intermittently. Does your gun reload after each blow, until the ammunition is used up?
Experiment 59. To make a four-way junction.
    Make a tee as in Experiment 56, but do not cut off the closed ends. Now attach a fourth arm, as in Fig. 79, and heat and blow gently as before to work the glass into uniform condition. Cut off the closed arms at equal lengths, smooth the ends, and your four-way junction is made.